Mini 18/24 and Helix

• Updated software experience, compatible with Legend 36EXT
• There is not a way to migrate .dat job files from classic driver

Minimum Requirements:

• Windows 7, Windows 8.1, Windows 10, or Windows 11
• Operating system should have all system updates before installation
• Support for OpenGL 3.0 (or higher) or OpenGL 2.0ES (or higher)
• 4GB RAM or more
• 2 processor cores or more
• Processor can be any Intel i3/i5/i7, AMD Ryzen 3/5/7, AMD A4/A6/A8/A10/A12/FX
• Integrated gigabit ethernet is not required, but is nice to have.

Recommended Specifications:

• 8GB RAM or more
• 4 processor cores or more
• Processor can be any Intel i5/i7, AMD Ryzen 5/7, AMD A6/A8/A10/A12/FX

Mini/Helix Driver 9.03 (01/07/15)

• Warning! If you are using DAT files in your driver you must update them with the DAT converter software below.
• Fix for vector sorting commands sent to Job Manager.
• Adds support for the Epilog Job Manager.
• Optional: Download individual files.
• Download install instructions – Windows 7-10.
• Download install instructions – Windows 11.

DAT Converter (08/15/14)

• Convert your DAT files if using driver version 8.08 or earlier.
• Download install and use instructions.

Epilog Job Manager 1.3.6 (01/15/16)

• Improves how the software handles hairline vector lines that extend off the edge of the page. This change only affects the Fusion Laser Series.

• Warning! Install the driver before the Job Manager to properly associate your driver with the laser.
• For more information on the Job Manager, click here.
• Download install and use instructions.

Firmware: 1.0.3.0 (03/10/11)

• This release fixes an obscure bug in Mini/Helix systems that caused inconsistent engraving on graphics that were raster only images, but run in Combined mode, with Air Assist enabled at the machine.
• Read Install Instructions.