Epilog Firmware Update 1.0.4.1

Note: Fusion Pro 36, Pro 24, and Edge 36 cannot be downgraded after upgrading to this version below 1.0.4.0.

Added Edge 36, Pro 36, and Pro 24 compatibility. Pro models have the additional features of:
- Stack light
- Air assist
- Faster X motor (120ips -> 165ips)
- Carriage camera
Power and frequency can now be modified while the job is running depending on job type and laser type.
Added dynamic raster ramps for improved raster speed
- Can be disabled in the settings menu

Fixed issue where job details screen would be shown in certain cases even if there wasn’t a job
Fixed issue with air assist not turning on for model 16000 Pros (1.0.4.1)
Fixed issue with pause button responsiveness (1.0.4.1)